| S. No | Description |
|---|---|
| a | Power connector, snap-in (NOT FOR WEARABLE RADIO) |
| b | Primary connector to Wearable Mesh Rider Radio |
| c | Pin header, 2.54 mm |
| d | Pin header, 2.54 mm |
| e | RJ45 connector, ETH1 |
| f | DNP |
| g | USB-C Host port |
| h | POWER_ON Pin |
| i | LED1, connected to GPIO1 |
| j | DNP |
| k | Reset Button |
| Pin Number | Direction | Voltage | Pin Description |
|---|---|---|---|
| PIN 1 | GND | GND | |
| PIN 2 | NOT USED | ||
| PIN 3 | NOT USED | ||
| PIN 4 | GND | GND | |
| PIN 5 | 0V to +2.8V | GPIO1 | |
| PIN 6 | GND | GND | |
| PIN 7 | 0V to +3.3V | UART_TX | |
| PIN 8 | 0V to +3.3V | UART_RX |
| Pin Number | Direction | Voltage | Pin Description |
|---|---|---|---|
| PIN 1 | O | 0V to +3.3V | FAN_CTRL (do not use) |
| PIN 2 | O | +5-V | 5-V, 1A Power Supply for USB |
| PIN 3 | I | 0V to VIN | POWER_ON – default pulled high, pull low to trigger |
| PIN 4 | NOT USED | ||
| PIN 5 | GND | GND | |
| PIN 6 | NOT USED | ||
| PIN 7 | NOT USED | ||
| PIN 8 | NOT USED |